GNS3 is a network simulation software that allows you to emulate and configure network topologies. While I can't provide you with specific lab configurations or step-by-step instructions, I can give you some examples of CCNP-level labs that you can build in GNS3.

some tips for setting up CCNP GNS3 labs:

·         Use a powerful computer. GNS3 can be resource-intensive, so it is important to use a powerful computer to run it.

·         Use a large monitor. GNS3 can be complex, so it is helpful to use a large monitor to view the simulation.

·         Use a network adapter with multiple ports. GNS3 requires a network adapter with multiple ports to connect the devices.

·         Use a virtual machine. If you do not have a powerful computer, you can use a virtual machine to run GNS3.

Once you have set up your CCNP GNS3 labs, you can start practicing for the CCNP certification exam. You can find a variety of CCNP labs online, or you can create your own labs.

Here are the steps on how to setup CCNP GNS3 labs:

1.   Download and install GNS3. You can download GNS3 from the official website.

2.   Download the IOS images for the Cisco devices you want to use. You can download IOS images from the Cisco website.

3.   Create a new project in GNS3. To do this, click on the "File" menu and select "New Project."

4.   Add the IOS images to the project. To do this, click on the "Devices" menu and select "Add Device."

5.   Configure the devices. You will need to configure the devices with the appropriate IP addresses and subnet masks.

6.   Connect the devices. You can do this by dragging and dropping the devices onto the canvas.

7.   Start the simulation. To do this, click on the "Start" button in the toolbar.