How to put curtain rod without drilling?

Curtain rods can add a bit of personality to any room, but they can be a bit of a pain to install. In this blog post, we will show you how to put curtain rod without drilling. By following our simple tips, you will be able to install your curtain rod in no time at all!

Source:https://i.pinimg.com 

What you need

If you don't want to drill into your wall or you can't find a stud, you can use a curtain rod as a mount. Just insert the rods through the top and bottom of the tension rod, then screw on the caps.

How to put curtain rod without drilling

There is a simple way to put curtain rod without drilling - buy the pre-drilled rods and screws. You can find these at any home improvement store. The screws will fit into the pre-drilled holes, and then you just screw the rod onto the screws. This method is especially useful if you are using thin curtains or if you want to use a different type of curtain rod than what is typically available in stores.

How to hang a curtain rod without drilling

There are a few ways to hang curtain rods without drilling.

The first way is to use a hanger. To do this, find the middle of the curtain rod and insert the hanger into the hole in the center. Hold on to the top of the hanger and pull up on it until it’s tight against the curtain rod. Tie a knot in the hanger to keep it from sliding down.

Another way to hang a curtain rod is to use screws and washers. Find the hole in the wall where you want to mount your curtain rod and screw through it using screws that are about 1 inch longer than the width of your curtain rod. It’s helpful to pre-drill this hole so that screw goes straight through. Once you have your screws in place, put a washer on each end of your curtain rod and slide it onto the screws. Tighten these screws with a wrench.

However, for a much better installing of curtain rods, there are various types of tools that can be used in drilling your wall such as rock drill bit, rock drilling auger, rock drilling bucket, and many more.

Source:https://i.pinimg.com 

How to install a curtain rod without drilling

To install a curtain rod without drilling, use a screwdriver to unscrew the screws from the rods. Once the screws are loose, gently pull the rods out of the mounts and assemble them into the desired length. Connect each rod to its mounting by inserting the screw into the hole on one side of the mount and tighten it with a wrench. Replenish any lost screws and reattach your curtains!